🚙 Rugged Ridge 13611.15 Full Roll Bar Cover Kit for 1992-1995 Jeep Wrangler YJ Review

I have a lot of Rugged Ridge products on my 87-95 Wrangler. Always high quality, high performance devices, they have never let me down.

It is tightly packed in a small box so the foam has to expand. So be careful. There are no holes or zips on the halo for the windshield grilles. You must make your own.

Requires 2 patient people. very tiring. when they are on they look good. The filling is very cheap and breaks easily, especially the 2 pieces that go from the windshield to the roll bar on the crossbars. These two parts should be Velcro. I read the other reviews and bought it anyway and I shouldn't have.

I bought a return at a reduced price. It's worth all the price. I had no instructions because it was a return. Once I understand what's where, foam rubber is tightened first, and then zippers are attached over the foam rubber. It was easier there. Took me 2 hours figuring it out. So be patient and plan enough time to take your time. You will be satisfied with the final look.

Looks good and well made, the zippers withstood heavy loads during assembly and did not give up. However, make sure you have wrenches and strength to separate the front cage from the rear, and keep a utility knife CLOSE to pierce the lid where the screws go. These holes are not pre-drilled. Or just remove the front of the cage. Cell, if you have time I'll do it. I didn't do it because some of the brackets are a bit rusty, so.