🔧 Stubby Welding Accessories by RX WELD Review

I bought it back at the end of 2019, finally I could use it on 15/15/21. There was an issue with the holes penetrating the diffuser. I went through many frustrating steps to troubleshoot. Including using different lens sizes and tungsten, different sources of aluminum, different flow rates, etc. Only to find that I get the same problem when using the supplied gas lens chuck body. I went back to the OEM lens, my problems are gone. The included cups fit me, I had no problems with them at all…

I've only tried 1/8" and 1/16" gas lens collets and both are useless . They significantly restrict argon flow compared to CK and Furick. I had to increase the argon flow to the point where it hissed like an angry snake and fan the arc out everywhere to get enough coverage so my tungsten didn't turn into a spark monster that self-destructs. A noticeable limitation when attempting to blow it with your mouth. It should feel more like blowing through a straw than a sponge. The collets could also be

I bought a new welder, new argon tank, new torch and also bought a set of gas lenses. I put everything together to start welding mild steel and I'm having porosity issues. lots of bubbles and pops. Pollution like turning off the bottle. I've been brewing for many years so I'm starting to diagnose the problem. I make sure my solenoid is clicking and I have some pre-flow, continuous gas flow throughout the arc and my under-flow is working, that's verified. I check my system for leaks with a soapy