Scosche NN03B Nissan Power/Speaker Connector & Wire Harness - Color Coded Wires for Easy Aftermarket Stereo Installation (1995-2007 Compatible) Review

Perfect fit. Color-coded cables match perfectly. Easy to set up stereo quickly. Recommend if you need a simple stereo replacement.

Ideal for wiring. Installed a dual marine radio and everything went together smoothly. I turned on the radio and the BOSE amp. Perfect.

Should be plug and play. On my 2006 Nissan Titan with an inbuilt CD changer, the ground wire was in the wrong place. I had to run a ground wire to metal to get this adapter and main unit to work.

Fits my 2000 Nissan Maxima perfectly. Without cutting. The wires have been precut and marked for easy installation. Just hooked up the wires to my new deck and hooked them up to my old wiring harness and Tada! It works.

Be careful using this on a Nissan Xterra. I have a 2008 Nissan Xterra and my car uses single suspension instead of dual suspension. In addition, a second wiring harness is required exclusively for the radio antenna. Even though Amazon fitted it to my car, it didn't fit.

Was looking for a wiring harness for an aftermarker radio, this only works for Nissans that don't have a factory amp. This only works if you know how to buy one Happens because I had to do this to hold back your Bose speakers and factory amp. You need a different hardness plug. If you want to keep the amplifier's factory speakers, you'll have to buy it. Check YouTube for videos on bypassing factory amps

I was looking for post stamp radio wiring, this will only work on Nissans that don't have a factory amp, this will only work if you know how to buy skip because I had to do this to keep my Bose speakers and factory amp again? You need a different connector hardness. If you want to keep the factory amp speakers, you need to buy these amps easily homemade

Everything seemed fine. Some people laughed when I said I'd rather solder than crimp. That's why I'm leaving a review. The headers don't connect very well, my rear left speaker SHORTED very badly. The ONLY SOLUTION was to replace the wiring harness and service it, or put the speaker wire under load, or. After installing my new Kenwood I found that I DID NOT NEED a bypass and on my 2003 I just needed to connect all four BLUE wires together. Pathfinder SE after removing BOSE. In some vehicles you