SCStyle Inline Skate Socket 10XSilver Review

Not suitable for micro mini scooters as a replacement - I only got it from the manufacturer. I'm sure they will fit most inline skates.

Be sure to check the exact width of your skates before purchasing. They are longer than most; So they don't really match my skates. send her back

This was a great quality product and value for money but the size was too long for my needs. It didn't work with my reels and I had to return the product. The return went without any problems, I am satisfied.

I think it would be nice if screws were included. Their only solution to this problem is to return the product to them for a full refund. Great thanks, now I have to order from someone else. Just save yourself the hassle and order from someone else to get started.

Bad product. They were the wrong size and on my first ride on them the post detached from the shaft causing me to lose my front wheel and fall. Pulled my hamstring and took about a week to walk properly. waste product. Too thin and long. Spend the extra money and buy decent ones.

Affordable price. Seems well made and with a dot of blue threadlocker. I had to carefully file the threaded end to shorten the trucks to fit the width of the skateboard frame to avoid "riveting" the truck to the frame. Sawing was less than a millimeter, but it was a lesson learned from previous experience where axles that were too long flared out when tightened and had to be bored out to replace a wheel.

Advantages: inexpensive. fit (initially). Cons: WEAK. After a few weeks of inline skating I wanted to spin my wheels and found that the screw insertion points had widened making it impossible to remove them without damaging the bearings. I spent good money on my bearings and wheels and didn't think about spending good money on these spindles and now I have a set of wheels I can't get enough of. Do yourself a favor and spend a little more for a longer lasting product.

There is nothing wrong with this product, but its diameter is smaller than a conventional roller bearing. my fault The length is a little shorter, for me it was the $100 Zetra Blade that I was looking for a replacement stock for. I lost an impeller and needed a replacement shaft(s). Basically, albeit somewhat fortunately, I needed a man nut, if you can call it that. And it fits my original shaft. Edit: Actually I'm wrong again, this particular shaft is a bit longer (original), it's for the…