🚘 SEO-Optimized SEALIGHT H10/9145/9140 LED Fog Light Bulbs: 4000 Lumens, 6000K Xenon White, Non-Polarity, 9045/9040 LED Fog Lamp or DRL Bulbs - Halogen Replacement for Cars/Trucks Review

Did not fit the 2006 Ford Explorer. I had to shorten the mounting tabs a bit to fit. The connections were in reverse order. The lamps did not light up when the plugs were connected to the holder. I had to flip them over and then tape them in place to keep them from falling apart. Because although they have a whiter light than the original halogens, they are not as bright on the road.

These bulbs look absolutely fantastic. Unlike many available incandescent bulbs, LED chipsets are positioned exactly where the factory bulb element is located, making optimal use of the headlight's reflector housing and producing a strong beam of light rather than just diffuse light. I couldn't be happier with these lamps. I installed all three for low beam, high beam and fog lights. Looks amazing and has gotten tons of compliments in just two weeks of using it.

These LED bulbs make me smile every time they light up. The installation for my 2018 F150 XLT was smooth and hassle free. The bulb and cord fit perfectly so the factory dust caps seal properly when reinstalled. I've been using them in my fog lights for a month without a single hiccup. They continue to shine through snow and rain. Several people have commented on how light they are and how "beautiful" their bluish hue is. I've attached a photo with just the fog light installed on the driver's…

I installed these on my 2018 F150 Lariat Sport to replace the halogen bulbs. Light output and pattern are excellent! One of the main advantages was the fanless design. In the fog lamp application on F150, the headlights are not protected as the headlights, so dirt, water, salt, snow, etc. can get on them, easily damaging the cooling fan. The headlights were a simple plug and play installation and took about 10 minutes to install on both sides of the truck. Overall, I am very satisfied with them

Blocked made to look decent and the position of the leds works well with the lenses of my Ford Ranger fog lights giving a nice wide fan with a sharp vertical demarcation. Can't speak to any other brand but the fit for my car was terrible! 914x lamps have a red O-ring behind the bulb for a water seal. Either the ring is too thick or the groove it sits in isn't deep enough. The lamp did not fully seat and would not rotate to lock into place, even with silicone grease. Installation was so…

Wow. The LED technology for locating headlights on cars is progressing rapidly! Very impressive With beam pattern and performance in fog Eluted at a 1:1 ratio. This guarantees the best light output and beam pattern Really impressive build quality! Fanless, so there are fewer components to fail. Sealight fits literally anywhere with no cap or body modifications. I am very happy with the results! Targeting victory! Plug and play! Use some protection for your connections and be sure to wear gloves

I was very happy to receive them and my halogen too replace lightbulbs. Unfortunately, when I installed the second one, I found that they hadn't glued the heatsink to the lightbulb. This is a big problem as you have to use the heatsink as a handle to rotate the lightbulb into position. And it also seems to be used to close electronics. If you remove the cooler, you can see all the cables. However, I'm a bit excited so I think I'll just stick it back on and then install once it cures. First…