🔥 Sellstrom Welding Helmet Flip Lift Front Adaptor Retainer - Durable Nylon Face Mask Accessory for Protective Auto Darkening Welder - 6"x3.3"x2.2" - Black Review

This product appears to be well built, looks elegant yet is durable. Cutting and installing was certainly a pain, but take the time to center them. The only thing I had to do was file the cap insert to allow my Arc lens to slide in, other than that I have no complaints.

Great product. It's just that I'm very careful how you cut your hood. There is no diagram so you have to decide where to cut. The difficulty is where the screws go. I used a cutting wheel and it worked great. If I had to do it again I would use a multi tool or a dremel for a finer cut.

I used the classic tiger hood before I got my conveyor belt from a mate at work, when I made the switch I realized how much I like the flip lens like. The only complaint is that you have to cut off the lens mount and hope you mount the Selstrom straight. It would be nice to have just the lens mount hinged front with nuts to hold it in place.

Works very well and I love mine. Be very careful when installing, don't do it like I did and don't cut too much on one side. The back panel hides it, but not completely. The hood is getting heavier, so I'm changing my hat. My old hat couldn't hold that much weight, but I changed it anyway. Good product, just wish it was lighter and easier to install.

This is a great addition to your helmet if you don't want to swap out the welding hood for a grinder shield. This saves a lot of time and is very practical. On the downside, attaching the flip front is a little tricky, but nothing major, and the flip top adds weight to your hood. Disadvantages aside, this product is a great addition to your helmet. Also note that the location where you insert your chosen lens is closer to 3/16" and one" than 1/4", so you may have to open it up a bit to fit your

After installing it on the hood, I immediately regretted it when I wanted to attach it and weld with it. Double puddle or almost like a glare when welding with it. I've heard some people complain about this and I've experienced it too. It's not scary, but it's noticeable, especially when you notice it, lol. It adds a little weight and it's harder to keep it from falling off if you're not welding and still carrying it. I have a Jackson headjoint that I attached to it so it doesn't have a latch…

Works very well and I like mine. Be very careful when installing, don't do it like I did and don't cut too much on one side. The back panel hides it, but not completely. The hood is getting heavier, so I'm changing my hat. My old hat couldn't hold that much weight, but I changed it anyway. Good product, just wish it was lighter and easier to install.

This is a great addition to your helmet if you don't want to swap out your welding hood for a grinding visor. This saves a lot of time and is very practical. On the downside, attaching the flip front is a little tricky, but nothing major, and the flip top adds weight to your hood. Disadvantages aside, this product is a great addition to your helmet. Also note that the location where you insert your chosen lens is closer to 3/16" and one" than 1/4", so you may have to open it up a bit to fit…

After installing it on the hood, when I went to attach it and weld, I immediately regretted it. weld with her. I've heard some people complain about this and I've experienced it too. It's not scary, but it's noticeable, especially when you notice it, lol. It adds a little weight and it's harder to keep it from falling off if you're not welding and still carrying it. I have a Jackson headjoint that I attached to it so it doesn't have a latch position, not sure if the original metal fiber…