🏎️ Pace Setter 70-1182 Black Exhaust Header: Optimal Performance for Your Vehicle Review

Great item. Fits great. The only downside is that the pads are not of very good quality. Update the pads and I'll give it 5 stars.

Would give 0 stars if I could. Gaskets are complete junk, barely fit. Hardware is rubbish, instructions are rubbish too. Oh, that didn't fit. I contacted the manufacturer a few weeks ago and they said they would send me another extension tube. Let's see if it fits

The manifold itself meets my expectations but was very disappointed with the quality of the gaskets. I spent an extra $45 on gaskets and Pacesetter can't provide me with a gasket solution for a catalytic converter that's still leaking.

Overall the Pacesetter was a great product. The manifold fits perfectly into the existing exhaust system. I only ordered a black lacquered header because it was significantly cheaper. However, I sandblasted the manifold and painted it with high temperature manifold paint. The only problem I have with the distributor kit is the seals. I would not recommend using some of the gaskets from the kit. Some gaskets do not fit properly and do not provide a good seal. I bought all the gaskets I needed at

This is my second header kit in 3 years. I had the same problem both times. The 3-hole flange does not seal well. I went through many pads in this section. For best results I recommend cutting the floating flange on the downspout side and using the flange on the other side as a deck to weld on the downspout. You must bolt it all the way down and install the O2 sensor before welding this section. The second complaint is that the two-bolt flange on the downtube side that connects to the CAT is…

I bought this for my 3RZ 85 pickup. It doesn't fit perfectly but if you hit the weld on the outside of the header a little it will clean up the 2nd generation frame. Where the primaries come out of the flange there is enough straight pipe that you can cut about 3/4 inch and weld back on for more clearance. You will need to remove the frame protection plate for the old 22RE fuel line and the line itself if you haven't already done so. I didn't like the flanged head gasket so I went with the…