🛋️ Shepherd Hardware 9345 2 Inch Medium Duty Furniture Casters Review

These antique wheels are definitely worth 5 stars. They have a great nostalgic appeal. They're sturdy and well-made no matter what country they're made in (my response to another reviewer who seemed to snub China). The wheels are easy to assemble. Just drill a hole according to the instructions. The sleeve slides right into the hole, and then the teeth plunge into the end fibers of the wood with a hammer blow. The wheels snap right into the sleeve with a slight pop. Wheels come with grease. The

I wanted to change the wheels on my father's office chair. I estimate the chair is about 80 years old. The original wheels (which I still have) are wooden and one had a small chip broken off which seriously affected its roundness. These wheels looked like a good modern replacement for hard rubber wheels. The retro look is great. And hard rubber wheels on stone floor are good too. And replacing the old wheels was quick and easy. Now the problems. First, there is camp. (see first photo, only 2…

rolls well and is easy to install. Smooth rolling and a great way to protect wooden floors. I chose not to make 3/8" holes for the shaft holders, but instead drilled 5/16" holes for the rod (.31" diameter) and then used window sealant to make sure they didn't slip out would but still be can be removed in the future and damage the legs.They are used on a small Eastlake dresser with a mirror and the dark finish worked great.

These antique reels are definitely worth a 5 Stars. They have a lot of nostalgic appeal. They are sturdy and well made no matter what country they were made in (my reply to another reviewer who seemed to snub China). The wheels are easy to fit. Just drill a hole according to the instructions. The sleeve slides straight into the hole, and then the teeth plunge into the end fibers of the wood with a hammer blow. The wheels snap right into the sleeve with a slight pop. Wheels come with grease. The

Woman has a heavy oak jack that matches the dining table, chairs and china cabinet. Two rollers caught the carpet and partially came off, then bent the shaft. I looked for replacements, found them and ordered two packs to get four new reels. I probably should have ordered smaller ones as they were slightly larger than the ones I replaced and the wheels didn't clear the server rock when installed into existing mounting sockets. I cut new mounting blocks from scrap 2x4 stock and drilled holes for