🔥 High-Quality T18 Soldering Tip Set – 6pcs Replacement for Hakko FX-888D, FX-888, FX8801, FX-600 – Includes Tip Holder Review

Designed for Hakko stations but perfect for Ryobi units. I have a 65w battery/AC hybrid station that works great in this unit - very even heat, just like the OEM tips.

Great tips. Well made and fits perfectly. I like two very small tips for surface mount components. The only problem is the holder. The large shovel tip does not fit in the holder.

I'm no pro but they seem to work well. I don't notice any difference in the heating time. I would recommend them to a friend and would buy them again if needed.

Haven't had a chance to try these out but they seem to be well made and the same size as my other tips. Like the holder they came in so they aren't floating in one of my drawers now.

I had a broken Xbox One controller (poor potentiometer on the right joystick). The precision angled tip allowed me to desolder the defective sensor and solder in a new one without touching the board. The tip fits my xtronic soldering iron perfectly. Highly recommended.

I like the variety of bits but they take a long time to heat up and I have to use the highest temperature on my Haacko 688. I work with stained glass and the heat breaks the glass. I suspect that at lower temperatures I'll have to pay a higher price for the bits that come with the soldering iron.

I was a bit nervous about buying these as cheap parts for high end devices are often junk. However, I've been using one of these bits for a few months now and it's perfect. It takes a little longer to reach temperature (presumably it contains more metal), but it wets it just as well as the Hakko, cleans up just as easily and shows no signs of breakage or other problems. I am very happy with it.

The product could not withstand my moderately intensive use at the time. The tips oxidized after a few days of use for about 2 hours a day for 2 weeks. I often had to change nozzles and even order more. The Hanmatek SD2 station comes with 5 nozzles. Good for light use, I would go to Weller or Jameco to buy more.

The tip that comes with the soldering iron heats up to the tip. But with those tips and the same temperature, the solder won't melt. Above the tip, where the metal appears to be different, the solder melts. This problem made the tips worthless to me, so I'm returning them.

Soldering tips are difficult to check - they either work properly or they don't. To be honest I bought this set more for the tip holder than the tips but I thought what the heck! I'll try. I had three original Hakko tips that matched three ShineNow tips, so I tested these tips individually. Here's what I found. The Hakko tips seem to heat up quicker than the tips in this kit, but no more than 10 seconds. However, after being reheated and "seasoned" like you would with a new tip, the ShineNow…