Header banner
Revain logoHome Page
silicone leveling heat resistant buffers creality logo

Silicone Leveling Heat Resistant Buffers Creality Review

1

·

Poor

Revainrating 2 out of 5  
Rating 
2.0
🖨️ 3D Printer Parts & Accessories, 🏭 Additive Manufacturing Products

View on AmazonView on ЯM

Media

(4)
img 1 attached to Silicone Leveling Heat Resistant Buffers Creality
img 2 attached to Silicone Leveling Heat Resistant Buffers Creality
img 3 attached to Silicone Leveling Heat Resistant Buffers Creality
img 4 attached to Silicone Leveling Heat Resistant Buffers Creality

Description of Silicone Leveling Heat Resistant Buffers Creality

These kit is 3 long plus 1 short mounts, used for Creality CR-10, CR-10 V2, CR-10 MINI, CR-10S, Ender 3 , Ender 3 V2, ender 3 pro, Ender 3S series 3D printer. These Silicone leveling bed mounts replace the bed springs perfectly, Silicone rubber helps to reduce any vibrations compared with other solid plastic material, It has better stability than the spring, and the hot bed platform can be adjusted freely. Package: 3pcs long height is 18mm, 1pc short height is 16mm, OD 16mm and Through hole ID is 4mm. PAY ATTENTION: Ender 3 has contained the spacers, so no need to print the necessary parts, you just need to adjust the limit switch module's height, If your printer is CR-10,You need to print two printed parts before using it, please search "Solid Bed Mount " in the thingiverse to get them. These silione mouts can take up to 200 degrees, which is really higher than bed temperature.

Reviews

Global ratings 1
  • 5
    0
  • 4
    0
  • 3
    0
  • 2
    1
  • 1
    0

Type of review

Revainrating 2 out of 5

What is the most important thing to know?

So far everything is fine with them. When you get them, make sure you crush them about halfway or you'll drift at bed level. With proper installation, leveling your bed is often a thing of the past. I would actually give it 4.5 stars based on the color of the silicone, but that doesn't affect the function in any way.

Pros
  • PLEASE NOTE: The Ender 3 includes standoffs so you don't need to print the required parts, just adjust the height of the end switch module. If your printer is CR-10, you need to print two printed parts before you can use it. Search the articles for "Solid Bed Mount" to get it.
Cons
  • old