🔧 Enhance Your Dodge Ram with the Silver Double Din Dash Install Kit Featuring Wiring Harness & Stereo Compatibility Review

Insert was easy to cut and install. The rest of the instructions were very vague with no wiring instructions. I bought a Pioneer AVH-210EX, the deck fitted well but I had to flip the brackets to get it in the right position. The wiring is fairly straight across the board except for the red wire on the Dodge which is for key on power on and will need to be spliced. There is no wire in the factory wiring harness so you need to connect it to the cigar lighter plus with a jumper wire for the radio…

available This worked great for a 2008 Dodge Ram 1500. As others have said there are no instructions and I wish I had taken pictures of the setup for others but forgot. So here it is in typed format1. Cut out the crossbar 2. Shave 1/16 or less on the sides and top. DO NOT CUT THE BOTTOM. I used a diamond cutting wheel on my rotary tool. There is a clip point on the underside for the bezel, make sure not to cut the clips on the dash. The upper part of the front panel snaps into tech.3. Place the

This is the nicest kit, it matches the silver color of my existing dashboard perfectly and gives it a real factory look once installed. It does require some trimming of the existing radio hole, but there's nothing a small Dremel tool (with a cut-off wheel) can't do. I'm sure you could use the file, but of course that would take longer and require a bit more work on yourself. It is extremely secure even after installation. I'm glad I sent back the black one I bought before I found this one. I…

The kit was used on a 2009 2009 RAM 3500 (3rd gen) to install a 6.2" Sony double din. It was a great kit with clear instructions and everything what you need to install your double din. The antenna adapter is firmly in place. The wiring harness adapter fits the truck and the new stereo system adapter. Tip: The adapter wiring harness has two ground wires (black) and two permanently hot battery wires (yellow). Simply connect one of them and connect the other to your stereo. There is also a brown…

Kit for a 2009 RAM 3500 (3rd generation) to install a Sony 6.2" double din. It was a great kit with clear instructions and everything you need to set up your dual computer. Noise. The antenna adapter is stuck. The wiring harness adapter fits the truck and the new stereo system adapter. Tip: The adapter harness has two ground wires (black) and two permanently hot battery wires (yellow). Just close one of them and connect the other to your stereo. There is also a brown wire on the adapter harness

Great value if you are looking to fit a double desk in your Dodge. I have a 2007 Ram 1500 ST and with a little work it was easy to install. You will need masking tape, a pencil and a dremel with the sanding cylinder set on low speed. Tape it to prevent chipping of the factory paint on the panel, mark lines 1/8" from the edge and take your time to remove the plastic. You can always remove more, you can't add anything back Pros: Looks clean Matches factory paintwork Matches my Kenwood DNX692…

The only reason for 1 star is because it came and the mini console removal instructions were accurate enough. First I used a standard two DIN touch screen. I removed everything per the instructions, just used an 8mm socket instead of the "Phillips" screws as the instructions said. No problem. Easy to customize. Next, I follow the instructions to remove the center button placket for the bag. again. bright. Now the nightmare begins. To say it doesn't fit is an understatement. It was over 1/4 inch