🛹 High-Performance 16 Pack 608-2RS Skateboard Bearings: Fast, Smooth & Silent with Long Life. Perfect Fit for Longboards, Inline Skates, Scooters, and More! Review

The box the bearings came in is broken but the bearings are fine. They are covered in quite smelly oil so you have to wash your hands after handling them.

as in the description. They don't spin very well, but overall very well. Grease or something similar should give them a bit of friction. Like camps for spinners, they are 8/10. The price of the product is great.

Creates some fun spinners that I've 3D printed and given away like never before. I plan to order many more as the interest in Fidget Spinners has drastically exceeded my expectations. Kudos (and thanks) to LoveWaffle on Thingiverse for the spinner design I used - [.]

Bought these for center bearings for my engineering student 3D printing spinner projects. The spin time was terrible. Even with the bearing caps removed we were only able to get 2-3 seconds of spin time, while cheap basement bearings give us at least 15 seconds. Returned immediately. Maybe good for skateboarding but NOT good for spinners.

I bought these to replace my boys scooters that have been damaged from excessive off road riding. They fit on the wheels of your RadioFlyer Pro Glide. They offer reasonable performance. Maybe not at the level of the original bearings, but good enough. And with 16 in the pack I now have plenty of extras for when they decide to ride their scooters through the dirt again.

While I skateboard, I bought them for needlework (spinners), not for skateboarding. They worked fine for this purpose, but I also had a couple of old Red bearings to compare and the old/used Reds ran faster and longer than these new bearings. So I would say it's ok for a cheap entry level board but not for more serious riders.

Good balance between price and quality. If you remove the seals and clean them with alcohol you can get some of them spinning with very little friction for your spinners. I wouldn't recommend it for any other application. I have used them for various projects in the workshop and when replacing roller bearings. They aren't covered in any goo like many others, but be sure to buy from the real seller of this product: XiKe. I think some of the complaints came from other sellers with a poor quality…

I've ordered a lot of spinner bearings and I have to say this 16 pack I got from XiKe was the best. Especially for the price! They are very easy to clean with water and dish soap (followed by a quick wash in alcohol and a quick dry with an air compressor). Also, and this is important, there wasn't a single mistake! Each of these camps turned out to be excellent. Nice and smooth performance and I have no doubt that they are ABEC-9 compliant. However, there is a BIG PROBLEM with these bearings…