🔄 Inverted Capacity of Skelang's Industrial Machines Review

Used in conjunction with cables and counterweights for a lightweight pulley system. Good workmanship and quality. That is a lot. You couldn't make them yourself cheaper.

I have used these wheels to support a rope system for hanging deer etc when skinning. I welded them to the support structure with no problem, they carry the full weight of the attached load and roll freely. would recommend.

I use these as rollers for my homemade 36 band saw. They arrived on time and upon inspection I was very happy with them. I was concerned they might not be strong enough, but they seem more than strong enough. They have a pin and bearing design. Woohoo they were advertised as well and happy with this purchase will buy from them again.

Overall they're pretty well made but my only concern is the screw that goes through the bearings. The bolt fits snugly into the bearing near the bolt head, but the side facing the nut doesn't go in and has some play. I suspect it's the threads on the bolt, not the collar bolt, that would eliminate this play. The overall design otherwise looks very good.

I have bought 5 sets of 4 of these rollers for a project in the last 6 months. I couldn't buy them all at once due to limited quantity when ordering. When I unpacked them for use today I noticed that some kits had an oversized bearing cutout that allows the bearings to go in very freely and the outer race of the bearings rotates in the cutout where they are to be installed. They are generally not suitable for carrying loads because the bearing is not fixed in a recess that allows the bearing to