💪 Enhance Vehicle Stability with Skyjacker C966SBL Sway Bar End Link Review

Great product! It was installed on a 2003 F150 XL Crewcab with a 5" raise front suspension and worked very well. Outstanding quality and performance. Thanks very much!

I have 7-9" Mcgaughys on a Silverado, they're worth the money. Just make sure you tighten them and then check them every two or two days.

The seller should have been suspicious because they didn't state the actual length and dimensions of the item, but did only the packaging dimensions! These stabilizer links WILL NOT WORK with a 6" jack. 06 Silverado 2500HD Duramax

I ordered this product to replace a broken Rancho Stabilizer End Link on my 2005 Hummer H2 Lift. Rancho stopped making my lift kit. After searching Revain for a possible replacement part, I found this one. Easy installation and perfect fit. The item makes a very solid impression. Hard, thick band. sleeve is not required.

Just what you need to replace the existing stabilizer bar. I believe mine was an older version of this. It looked very different, but the size and fit were right. The overall length is 15 inches, the inner length is 9 inches. I bought my truck used and couldn't tell what lift kit they used. This stabilizer was installed on the Ford Ranger XLT.

These stabilizer links are a great replacement for my old Skyjacker training links. The old ones seemed to have been installed upside down and the ball joints were really worn and cracked. These new ones are really good quality and look sturdier than my old ones. The screw at the top looks close to the upper arm, but doesn't touch it through the full range of motion. The bolt sticks out a little so you can trim off the excess.

Installed in June on my F150 03 with 6" lift at 35s. Seemed vigorous, strong at first and went in without much effort. I'm not sure if it's the Minnesota winter and the salt, but the boots are already ruined and the game is definitely more than I'd like. Considering that between them and Fabtech's hard end links you'll no doubt have to cut it due to the torque setting, I still haven't decided whether or not to try them again.

This really fits my pulled up 14 Ram 1500. It's generic so it might work for your specific application. Finding longer replacement links is not an easy task as I have a 6 inch lifter. The ones on my truck looked like factory extension links. I stumbled across them and tried them. Surprisingly, they work well. Over time we will see how durable they are. There are no instructions either. If you pay attention to removing the old ones, installing the new ones will be easy. Otherwise pay a…