📺 Skywalker Signature Series SKY32813 6-Inch Heavy-Duty Wall Mount - Pack of 2 (SKY-32813) Review

Brackets are very well made, but be careful when interpreting the given measurements/sizes. When working to tight tolerances, such as For example, mounting the antenna a certain number of inches from the wall of your home will not give you EXACTLY the same distance as the product description states.

I have changed my original review based on the speed of shipping and the appearance of the product. It was a hasty decision. After actually installing the jig to hold and stabilize the 1-1/2 pipe. The strap was deformed (bent) and the grip was loose. Consequently, in light winds, the antenna at the top of the mast rotated and behaved like a weather vane. Not good.

Used to mount a fiberglass antenna mast (6m copper J-Rod) that came loose about 10ft off the ground. The mounting holes are 4" apart and slightly wider for a 4x4 rack, so I mounted them on cross pieces that attach to a 2x4 rack. These brackets are very strong and difficult to bend with minor adjustments. They can withstand strong winds.

I installed a cell phone booster in my cabin as the cabin signal was intermittent. Where I installed the antenna mast, at least 4 inches of clearance was required. Not wanting any contact between the mast and my roof, I ordered these 6" Skywalker Signature Series SKY32813 Heavy Duty Wall Mounts. They are strong, weather resistant, easy to install and provide the clearance needed. .

The part that attaches to the support is slightly bent. The more you adjust one or the other, the more it retracts, allowing you to adjust the vertical adjustment of the mast they are attached to. My mast was tilted slightly to the left, and by tightening the bottom bracket bolts I was able to pull the mast into a vertical, upright position. The screws supplied with the bracket have a low tensile strength. Be careful not to overtighten the screws or they may snap off. I did not use the screws…

I finally managed to get the product working. One of the U-bolts arrived on a threaded side, either damaged or not threaded properly. Poor quality control in this one. I had to roughly screw the included nut onto the bad end of the u-bolt. The nuts attached to the brackets came loose as soon as I touched them with a tool. The 4" mounting hole spacing worked well for what I needed. The brackets, once tightened, held the mast in place really firmly. If I had to do it again, knowing what I know…