🎵 SoundBox Connected 0 Gauge Red/Black Amplifier Power/Ground Wire Set - 50 Ft. High-Quality Cables Review

15ft lasted about a year before the cable, totally rusted, could not even run at 75 amps at 14.4 volts before dropping almost 6 volts to my inverter. However, this is my fault because of the CCA. I have not done my homework. And he had quite a heavy burden on him all the time; probably permanently 50 amperes at 14.4 V. On the other hand, the cable is very flexible! It was amazing hitting tight spots. "Use it for its intended purpose and you will have no problem."

I gave this product one star because it can be very flammable to anyone using it to handle electricity over 5 amps. It heated up in 5 minutes with my 7.5 amp no duck air unit on my 6000 watt inverter. I was just testing and lucky I paid attention. I couldn't touch the wire because it was close to melting the rubber coating around the wires. The inverter is set (and should have been) to switch off if the wires overheat, but I didn't wait for that and switched it off quickly, otherwise it could…

If you plan to put about 1500 watts or a little over 200 amps into the system, I would not recommend this wire or fuse box. It's copper clad aluminum which is a cheaper grade of pure copper and I've learned that having pure copper is important, especially in a high power system. I have two batteries of 70-80 Ah each and a generator of about 90 Ah. I use one skar audio RP.3500D and two skar 12 1500W RMS each. This isn't the best zero gauge wire and I would definitely recommend going with a…

I bought this kit to hook up my amp and have experienced many strange cases like it coming off again and not coming back. So my buddy and I tried redoing the floor because we thought it was a problem because it wasn't in the best spot in the car so we redid it a bit but we still had these random ones disconnections. So we ended up getting a test light and checked the power line from the battery to the amp and the light came on in one spot and not the other and then we went back to the first…

Can't rate the whole system yet as it just arrived. Of the individual components, I find the fuse box and its design very good. This is the best design and construction, who knows? This quality is sufficient for my application. This is NOT a weatherproof or waterproof fuse box. The fuse is adequately protected for normal conditions. As for the *0* gauge wire itself, it looks fine on the spool, but that doesn't mean much. All I'm going to do with it is turn on the 1000 watt PSW KISANE inverter…