🔧 SPC Performance 32111 Wheel Centering Tool Set for Optimal Alignment Review

They are a bit difficult to pull out when trying to get on the rear wheel. I mean they are too short. Get 2 rims with brake drum. The front works well. Better than nothing, money can do a lot.

The tubes are the same length as the trailer hub studs so there is a hole which should help you to align them to pull out after centering, useless , the tubes get stuck and you have to unwind the straps to remove them. and after that there is no centering. I cut them in two and lived on studs.

They're a little hard to figure out when trying to look at the Rear wheel to rise what I mean They are too short to get 2 rims with brake drum Fronts work well Better than nothing they do a lot for the money.

The tubes are the same length as the trailer hub studs so the hole to pull them out after centering is useless, the tubes get stuck and have to be loosened to clear them to remove. And after that there is no centering. I cut them in half and lived on stilettos. Who has design ideas, they are good, just an inch less.

I would not buy this. I had a set that could be screwed on with an electric drill. They need to be hammered onto a hairpin. And sometimes you can't get them off and have to remove the punctured tire to do so. Overall they work great but this set sucks. If they could be threaded, they would be perfect.