🔵 Spectre Performance 9776 Blue 4-inch Intake Coupler: Enhanced Airflow and Durability Review

Used it to replace the metal clamp on my Ghost intake manifold hoping the system was at least a little more watertight if not stronger.

This worked for my 2006 WK Overland Grand Cherokee 5.7 Hemi. A Mopar brand inlet clutch is $98 from the dealer or $70 from Amazon. This $10 Ghost saved me a ton of money.

quality product flexible size. I used it on my jeep commander on a 5.7 throttle body. One on the jeep is 3.5 inches, the other is 4 inches, but it was flexible enough to fit easily. This one costs about $10, and the one at the Jeep dealership is almost $100. Saves a lot of money

Just what I needed to add a waste water connector and metering valve assembly to my existing line. I had to cut out the old assembly at the linkage hub, leaving a 4″ diameter tube that I had to connect to the new assembly's linkage hub (the standard 4″ rubber linkage was too big as it's almost 1/2″ too big ). than 4"), but it fits perfectly, is tight and still hasn't leaked after weeks of watching.

Made from unreinforced synthetic rubber. Fairly high hardness. It is not amplified as one person's comment says. Its length is only 1.97 inches or two inches. This should work fine for my cold air line connection. It will be interesting to see if it can withstand the heat of the turbocharger side joint and if it doesn't squeeze out from under the clamp so much that it weakens.