Header banner
Revain logoHome Page
πŸ“Œ 500-count sps f075 0.75-inch thread pocket logo

πŸ“Œ 500-Count SPS F075 0.75-Inch Thread Pocket Review

3

Β·

Average

Revainrating 3.5 out of 5Β Β 
RatingΒ 
3.7
πŸ”© Screws, πŸ”© Fasteners

View on AmazonView on Π―M

Media

(1)
img 1 attached to πŸ“Œ 500-Count SPS F075 0.75-Inch Thread Pocket

Description of πŸ“Œ 500-Count SPS F075 0.75-Inch Thread Pocket

Square-drive head and self-tapping tip for easy driving without bit slipping, wood splitting. Flat-bottom head and smooth shank draw the pocket-hole joint together tightly. Case-hardened steel won’t bend, snap, or break. Fine threads for hardwoods such as oak, cherry, maple. Pan-head screws for use with Kreg Micro-Pocket pocket holes.

Reviews

Global ratings 3
  • 5
    1
  • 4
    1
  • 3
    0
  • 2
    1
  • 1
    0

Type of review

Revainrating 4 out of 5

Required for 1/2 inch stock.

These are amazing screws. Hard to find. This is the screw length for use with 1/2" material. I used this to install Azek faux paneling in the bathroom. When used with the Kreg system it works/looks amazing. As you know me what the hell I was doing.

Pros
  • Wood Screws
Cons
  • Not sure

Revainrating 2 out of 5

About half of the box has arrived.

When I picked up the box it came in the screws started falling out of the bottom. The lid had been removed from the original packaging, there were screws all over the box and they found a piece of cardboard flap that was not securely sealed with tape. Big disappointment. How should I handle it? I need a full box.

Pros
  • Industrial & Scientific
Cons
  • The cable is shorter than others

Revainrating 5 out of 5

The best countersunk screws on the market.

Kreg invariably makes the best countersunk screws on the market. I wish they made SPS 3/4" coarse thread screws, or at least a Hi-Lo version. You need these screws for all micro jig projects. I use them to build a 12mm Baltic Birch box . Don't overdo it. Tighten them or they will loosen. If you set the hole and clamp stop correctly, you can use coarse 1" SPS screws in 12mm plywood applications. Keep this size and 1 Inches ready for drawer assembly and for attaching drawer fronts to drawers.

Pros
  • Screws
Cons
  • Very Expensive