🔧 Steelex D1060 Pocket Hole Guide: Enhanced SEO-Compatible Product Title Review

As other users said, I got chips from showing off from the start. Accuracy is reduced and now both sleeves are stuck in the drill bit and detach from the jig. I consider it a waste of money. Craig, I'm coming.

I bought this because I didn't want to invest a lot of money in something that would sit in my desk drawer most of the time, the small learning curve suits me. . This jig is not a substitute for learning proper tongue and groove craftsmanship and other joinery skills that really make a project beautiful.

Purchased about 10 years ago. I've never been so impressed. The results were marginal at best. I used it this morning and it cut such messy holes that I called a friend who was thrilled with his Kreg and asked if I could borrow it for the day. I used Kreg today and it's the best in every way. Easy to set up and use. It cuts perfect holes and the joints are very tight. Woodstock's in the trash and I'm ordering Creg.

A difficult product to use. It tends to slide too much even with the right clamp. I recommend Herculiner Truck Body Spray to stabilize the underbody and protect the guide from excessive vibration and movement. A second clamp is also useful for holding both rails. For best results, the manufacturer recommends a 3/8" step drill with a 1/4" tip. Remember that the bits are quite large and cannot touch the ferrous metal pilot holes into which the bits are inserted, otherwise the metal will easily…