🌟 Enhance Your Studio with Studio Designs Light Pad Support Bars in Sleek Silver - 10049 Review

The light weight pad can only be used in one place and in one direction due to the design of the bar and table. Forget it if you want to take a vertical picture or something bigger. Huge glass top but tiny area where a light pillow can fit on the grille. Very disappointed

Fits perfectly with the Vision Craft Station with the following dimensions: Dimensions: 28"W x 42.20"D x 28", Main Worktop 35.5"W x 24" " G, Nice powder coating. However, be careful when disassembling, the holes are very easy to remove as the metal is thin, which is a problem with the table, not light cushion support rods.

We installed these poles and it was very difficult to slide the light box in and out and access the power button. Our desk has small pencil/eraser holders on the sides and I think this caused difficulties and rendered these slats unusable. We returned them. You don't have to sell them to work with all of their desk designs. Also, you can only place the grate in one spot above the drawers, making it even more difficult to use.

These are basically two aluminum poles that allow you to mount a portable light box under a glass panel. The problem is that the Artograph box it's supposedly designed for has a power button on the top of the unit. How do I turn it on if it's there? It is much better to use another light box with a switch built into the cord. Given that Studio Designs and Artograph are part of the same parent company, this should have been more thoughtful.

I like their concept but they don't fit my desk. I ordered them by trial and error. I own a L-shaped corner table Jameson LS by Studio Designs, black and clear glass #50300. It wasn't said to fit that particular style of desk but I needed something similar so I bought it. They are too big for an L shaped table and at the moment I don't think there is a similar product for this table. I've seen them installed on the tables he listed and am sure they will work for them.

I took a chance because I couldn't find any information if there are special grooves for it that would prevent it from working with 12x17. There aren't any and it works great with 12x17 because it has no chance of falling out and also the lightbar switch had a 1.5 inch gap to turn it on and off. I really think the craft station and the 12x17 light bar are the perfect match in my apartment! I also have a wrist lamp with a metal clip, I would recommend going to your local or nearest hardware…

The rods themselves are fine. Simple and beautiful. Here you are forced to mount them under the table, which leads me to give this a low rating. To the left of the table are holes for attaching metal bars. You cannot place metal bars elsewhere. By moving the metal bars and then your light box to the left of the table, the light source is instantly reduced for right-handed people. Of course, if you're right-handed, you'll lean closer to the right side of the table than anywhere else. Unless you…