Waterproof 12V LED Trailer Light Kit for Submersible Heavy Duty Utility Trailers - Carrep (2pcs Square Trailer Lights) Review

Easy to install - just remember to figure out which is left and which is right before you route the cables. It would be helpful if the lights came with instructions and wiring diagrams.

that turned out to be rubbish the cables are completely unusable after about 15 uses the light stopped working when i tried to redo the connections. was not possible as the internal copper wiring was COMPLETELY destroyed and turned to white powder! Only used in fresh water Installed correctly even turning the lights off every time the boat is lowered turned out to be a waste of money :(

With this lamp set, almost everything was standard except for the yellow side light. It featured two small screw holes instead of one screw, so a total of 4 small diameter holes had to be drilled. I broke some drill bits while drilling through the steel frame. Also, since the trailer is grounded, the ground wire must be routed back to the taillights. Also, they only offer 6 spring clips to attach the two main cables to your trailer. It took me twice as much to securely attach the wires.

Troubleshooting everything I could think of and finally a BAD 4 PIN CONNECTION. The whole time I thought I had done something wrong. DISSATISFIED. This design is not perfect. All must be grounded at the attachment points. Separate bases for each light are bananas. I don't recommend it as 20 year old trailer lights are easier to install than these. .LEDs are super bright. It is very nice. The seller owes me $8.99 plus tax to repair a 4-pin connector. Don't buy this. Pay $20 extra for top brands.

I have started and restored my boat about 4 times since it was installed. Recently discovered they both contained water! I had to drill drain holes but that already touched the turn signal on the right side. Rusty water came out. First drive on the freeway 6 miles to the local onramp and the new license plate broke. The plastic must be complete rubbish considering I've never driven over 90km/h! Most likely they will have to be replaced within a year and I will have to pay for the number plate…

All lights are LED unlike some cheaper options where the side indicators are incandescent. The headlights appear to be well made and waterproof - there is sealant where the wires come out of the bulbs. The mounting studs, nuts and screws appear to be stainless steel, with the included position light screws being totally unsuitable for the short self-tapping screws. My main point is that electrical connectors are very cheap and in the case of ground wires there are none at all and by no means…

Lighting kit was purchased for the boat trailer as it was LED. The kit included everything you need for installation. Everything was very easy to install and properly grounded. On the first headlight test before departure, all headlights worked except (1) tail light, all connections were checked, regrounded and tested with a test headlight. The right rear brake, turn signal and side marker light were on but had no rear running lights. Decided to go to the end of the trip due to time…

Firstly, the four-pin flat connector is not a conventional standard size. It fits perfectly with the included car wire harness but not the adapter for my 7 pin car wire harness. All other 4 pin spade connectors I've used over the years work great with this. The 3 pins are closer together and I had to bend the second and third pins further away from the first to get this pin to fit! The fork did not fit flush because the feet of the fork bolts were still too close together. I have a good…