Sukemichi JK Hood Latches for Jeep Wrangler JK Unlimited Sahara 2007-2017 - Eliminate Hood Flutter with Locking Aluminum Latches (1 Pair) Review

Looks nice, really scares. All you have to do is loosen the bottom hex bolts and your hood is open, or loosen the pivot buckles. In any case, they look good and hold the hood better than the stock ones. It would be nice to have dust caps on the lock.

I love the way they look on my 2015 JK and they really protect the hood better than the OEM. No instructions but pretty straight forward. The bottom screws are a completely different size than the top screws and are also hard to come by, but with a bit of patience they're quick to fit.

These bonnet latches have a unique look and don't look like regular latches. Fully adjustable for good hood alignment. They prevent the hood from moving up or down and eliminate jarring. Fits into existing holes on the JK Wrangler, should not rust and will lock.

I hated the hood vibrations you get on jeeps at speed. If you've ever seen Tommy Boy, you'll understand why. These locks offer high security, a unique look and the best driving experience on the highway. The assembly kit contains rubber pads to protect the paintwork and two keys for the pin locks. money well spent.

This bonnet lock set is a really cool and effective alternative to using the Jeep bonnet latch system with a regular key. This kit is strong and with minor adjustments, holds the hood up to 100 times more securely than traditional rubber latches. I haven't even seen the hood bounce even a bit since they were installed. I highly recommend this product.

. Well built but only time will tell how they hold up in the rain. I love how they look and feel, I have a set of Drake locks but these locks. Drake sells a version with a lock, but the price is well worth the money and expense. unclassified floor which I was worried about but it works fine and it's understandable why they changed the design.

Installation was easy and fairly straightforward so instructions weren't really needed although it would have been nice to have them. It would also be nice to have a way to measure the height of each screw on the product, like the markings on the hex shaft. I ran into an apparent problem with the previous version where the bottom horizontal screws loosen and the entire bottom of the shaft falls off when moving. If they send me replacement hardware I use red Loctite on all cross bolts. The bad…