🔥 Superfastracing 2" - 50 ft Lava Titanium Basalt Exhaust Heat Wrap Roll for Motorcycle Manifold Header Pipe Heat Wrap Tape with Stainless Ties: A High-Performance Solution for Motorcycle Exhaust Systems Review

I used this film to wrap the upper radiator hose on my engine. I found my motor had thermal foil which was getting rusty and old it was like normal thermal foil film so I decided to replace this on the heatsink and it's great it stays cool and I feel better with it .

Technically it should work. It consists of very brittle fibers and is dirty. The item description doesn't lie, you need gloves. Use eye protection while on it. I used brand names that were elegant and user-friendly. If you're working on a project that you want to look good and be a little easier to use, spend a few bucks more. Consider returning it.

Works great for the price. ONLY WEAR GLOVES! There's a lot of fiberglass in there. And it will leave you very itchy for a few days. I wrapped the charge air pipe which is very close to my manifold. I sprayed glue spray on the tube and the back of the wrapper to hold it in place. The clips that come with the kit are a little tricky to use. I ended up using stainless steel wire and a good pair of pliers.

The wrap covered my generator's flexible exhaust pipe and it seems to work well but I didn't realize that when I was wrapping the pipe I was covering myself in tiny bits of fiberglass which made me itchy and feel like I was I was covered with pins for a few days. I had to throw away the shirt I was wearing. The instructions say to wet the packaging first, but because flexible tubing is so prone to rusting, I skipped that step. To your discomfort!

Mounts visibly on the bike's exhaust pipe and also runs alongside the control pedal in hopes of improving the look and reducing heat build up near my foot. Both cut heat and look great. A little tricky to assemble on long pipes and gloves must be worn as paint bleeds when wet. Let it soak in the water for a little bit and disconnect before trying to install. These are my only installation notes. I didn't have a stainless steel tie tool so I just used needle nose pliers and it worked. Check it…

I used this to wrap my headers on my 302 SBF to keep underhood temps down and to help with the vapor lock issue. Using the method of laying each wrap in half allowed me to use a 50 foot roll per side. The header pipe temperature dropped from 530F+ to about 420F a few inches from the head. Although I've seen other people say they need to wear gloves after soaking the packaging, I haven't had any issues with gradients. However, I got very itchy from handling it. So if you're having trouble with…

This material looks like branded material. However, this is not the case. The app was as expected. You must wear gloves etc. I have used many different bandages in the past and this material is at the bottom of my list. I wrapped my headers and sprayed them with the appropriate silicone sealant spray. Links work as they should. I started the car to cure the foils and silicone. The smoke show continued as usual. After several heating cycles, I let the machine run for about 10 minutes. Because I…