🔝 Top-Rated Stainless Steel Exhaust Tip: Superior 28-6302 4" x 7" Slant Cut Oval Bolt-on Review

This product is easy to assemble and gives your exhaust a beautiful look. The finish will require frequent cleaning or it will begin to tarnish and rust. But it's still better than most exhaust extenders I've bought before.

This is the second time I buy this product. I fitted them to a 2015 Honda Pilot, the brackets were not needed due to the size of the pipe on the Pilot. If polished every two months they should hold up well.

I ordered this muffler 2 weeks ago for my 2007 Toyota Camry and it looks great. It was very easy to install and has an extremely strong grip (which can be adjusted). Makes my car more aggressive. Hopefully it doesn't rust, but so far it looks very solid.

but I could save. Put two of these in my car for $40,000? They really enhance the looks (at the right angle) because what should have been is that price. My problem is with the length and clamp systems. Most likely, I will replace it with expensive welded ones. Recommend friends with the right car.

I have a 2006 Mazda 3 sedan it fits just perfect and makes my car look a lot better as I put a body kit on my Mazda I was afraid it would damage the body kit but it doesn't. Now my car looks more aggressive with this exhaust. The installation is very easy. I installed it in my car for almost 2 years and 0 problems.

Seems well made for less money than comparable off the shelf exhaust systems. Note, however, that the three sheet metal connectors inside (you tighten them to clamp the existing exhaust pipe) don't allow for a lot of tipping; The exhaust pipe is usually directed straight along the same lines as the exhaust pipe. And yes, the device is oval, not round.

Beautifully finished and polished, perfect for Volvo bumper cutouts. The clamping brackets are only designed for the smallest pipe diameter. As your pipe approaches maximum diameter, plan for some trimming or sanding to get it to fit properly and find various fasteners to accommodate the changed length. a bit of custom fit to set it right. I also drilled a hole and put in a couple of screws to ensure the clamps could come loose.

Firstly the tips aren't bad but they do need to be polished/protected to avoid premature discoloration which I would recommend with all tips. Second, be prepared to spend 45 to 60 minutes removing the sticker and the thick layer of adhesive underneath. Now I've bought many handpieces in my life, but I've never had this problem. The decal, firmly stuck to the top of the laces pictured, is made for an evening when there is a lot of extra work to do and you wonder who in their right mind could do…