🔧 Top-quality ECCPP Lift Support Hatch Replacement Struts Gas Springs for Acura MDX 3.5L 2001-2006 (Set of 2) Review

So far they seem to be very good. If I can get 2-3 years of service from them before having to replace them due to pressure loss I will be happy as the price was so cheap.

Replaced the rear with a 2004 MDX and it works and fits perfectly. The exchange of both sides took no more than 5 minutes. Remember that if you remove a side, the door will fall down, so find a place to hold it so you don't crush it. **Update** BUYER ATTENTION; PRODUCT BECAME DEFECTIVE AFTER 4 MONTHS. very disappointed with the quality

Bought these for my 2001 Acura MDX after the old ones failed. They fit perfectly and were very easy to assemble. Good value for money. The only complaint I have is that they are quite stiff and difficult to squeeze. I can feel them loosening and biting so hopefully after a break they will feel better. Everything around me fits.

Initially the product worked fine but after 9 months one leaked and stopped working. This is very disappointing as the OEM part has been around for 13 years. Update: I contacted the seller for a warranty replacement as the product description stated a one year warranty. The seller offered a 50% discount in lieu of a replacement, but I will no longer send them money for parts that will fail in less than a year!

Fits perfectly on my 2002 MDX and the upper tubes are very strong even in cold weather. The package arrived faster than expected. I hesitated to buy them because they were very cheap. I'm glad I bought them. I only gave them four stars because I have no information on how long they will last. I have previously bought an expensive pair from AutoZone and they only last 3-4 years so I doubt I would go wrong with them as they were significantly cheaper.

I received the struts and they fit correctly, at first I thought I ordered the bonnet struts (they fit on the bonnet) but then I found out they are for the tailgate. Fit and work perfectly and the price is right! Installation Note: You remove the old posts by using a small screwdriver to pry open the cover at the top and bottom of the post. Just click to install (you may need to insert the same small screwdriver into the same slot to make this easier).

My previous props were rigid and the hatch had to be opened by hand. These new racks were easy to install and work great! I did the work myself but I would recommend 2 people as it's easier and smarter :) Update: They lasted until today October 21st. At first I was happy with my purchase as it solved my initial problem, but the pillars became quite stiff and it took me some effort to close the door. This became more apparent when I noticed that my friends struggled a little too, especially when