🔧 Gas Springs Shocks Struts for 2007-2011 Toyota Camry 6333 - Hood Lift Supports Review

Very easy to put on and at a great price. There's no reason to go to the dealer for something like this when it can be replaced in just a minute!

My 2007 toyta camrey hood fell off and I had to put a stick every time. It was very annoying. And now this Hodl move for us. And it does the job! Must get! You will not regret it!

Installed one of these on my 2007 Toyota Camry. Installation was easy after watching a 3 minute YouTube video and using a standard screwdriver. It's been a few weeks and everything is working fine so far. Will update if anything changes, but as the title suggests, so far so good.

Easy to install, great youtube videos on how to install, make sure you use a strong flathead screwdriver to remove the posts and make sure the thick part of the new post is set above when reinstalling. They snap right away. be careful

Product arrived quickly and well packaged, I looked at some instructions online and it did, took me about 10 minutes. It's been a few months since I bought and installed it and it's still working. However, I only installed one of the kits as the other one was fine in the car, so I can't say 100% that both work perfectly.

Item arrived well packaged. Product opened and checked. Looks great, won't bend or rot. Easy installation, took old one off and put this one on. Even though it was an inverted setup, I just looked at the angle of each point. It took me no more than 10 minutes for both racks. Just lift the locking pins and you're done. Repeat on the other side. Don't forget to clean the attachment point. So far, so good. The time will show.

Great price, perfect fit and quick delivery. Replacing both hood pillars took about five minutes and they hold the hood very securely. Just make sure the hood is fully open and very secure. They must be installed backwards from the standard racks. Just install the angled end in the same place as the original pillars (front edge of the hood) and they will work perfectly. I used a small flathead screwdriver to pry the clip on the old posts as I pulled on them and they popped off immediately. To…