💡 Enhanced Hard Drive Power Switch Module for 2.5 inch / 3.5 inch SATA HDD/SSD: Ultimate 4-Way Controller with TVS Protection Review

I wouldn't risk my power supply unit or my hard drives with this board! Under the microscope you can see that the solder joints (particularly the 15-pin drive power connector) are of poor quality: very tight pads (poor quality PCB drawings) with microscopic delaminations as well as microscopic solder splatter balls lying on the excess. / Raw flux. Cold solder joints. Gaps at some solder joints. Flux residue will remain on the underside and cannot be removed with water, detergent, or isopropyl…

anyway from the same area. I'm adding this to the review because you might think like me and have reservations. I used a 6-port SATA power switch that fits into a 5 1/4 bay in a homemade server. Unfortunately, I reconfigured and upgraded some physical servers and had to use that last bay for something else. I had seen them before a few years ago when I was checking, so I revisited them. In my case, I have an external mid-tower ATX case with no motherboard, just hard drives. It only has 3 outer…

Excellent power splitter, especially shutting down unused drives to extend life. Easy to install, easy to use, no driver or application installation required. necessary, simple and serves its purpose perfectly. I have 6 drives connected to my desktop, it's great to be able to turn off the ones I don't use all the time. This way I use less power, generate less heat, less noise and extend the life of the drives.

Great product, just what I was looking for to switch between three SSD drives and one mechanical drive. The kit includes all the mounting screws for cables and a switch, I will also adapt it to a floppy drive adapter. fits on the front of my case or you can just use it as is in an empty expansion slot on your rig, good price too

I wouldn't risk my power supply or my hard drives by connecting to this board! Under the microscope you can see that the solder joints (especially the 15-pin drive power connector) are of poor quality: very tight pads (poor quality PCB drawings) with microscopic delaminations as well as microscopic solder splatter balls lying on the excess. / Raw flux. Cold solder joints. Gaps at some solder joints. Flux residue will remain on the underside and cannot be removed with water, detergent, or…

This is a nice switch, a well made button with a green light letting you know the hard drive has power. I placed 3 internal hard drives in a secure "air gap" out of the reach of hackers and viruses and have 1 extra switch left. PC tower. However, I had an old computer and the slots on the back were full. I looked around the inside of my turret and found a spot on the rear "wide side panel" that wasn't covered by the motherboard. I saw that I can probably install a switch using hardware you can…

Great power divider, especially for shutting down idle drives to extend life. Easy to install, easy to use, no driver or app installation required, simple and does the job perfectly. I have 6 drives connected to my desktop, it's great to be able to turn off the ones I don't use all the time. This way I use less power, generate less heat, less noise and extend the life of the drives.