🦖 Secure T-Rex EZ Pass/I-Pass Holder with 3 Suction Cups - Black Review

My old setup consisted of loose, clear Velcro and double-sided tape. In this summer heat, it fell off every day. This product worked the best. Can be installed anywhere and holds up great.

Bought this for a motorcycle because it is inconvenient to stop with the bike and withdraw money to pay for a ticket. The suction power is great, even when it rains the thing doesn't slip over the windshield. EZ Pass is the way to go.

The design looks like a godsend but the packaging isn't that good. I liked that the transponder is easy to remove without removing the entire holder. My biggest concern was the way the suction cups were packaged. 2 of 3 were deformed and failed to return to their 'natural' shape and one had a significantly deformed edge. Regardless, the mugs seemed to stick to the windshield just like they should.

The Uni transponder fits in the thing, but very sloppy. Only one of the three suction cups will hold onto a flat pane of glass. Bought to attach my Uni transponder to a motorcycle windscreen and attach a tether to it. But since it falls right out of the bracket, it's junk. I don't know what transponder the thing is designed for, but not UNI. And the suction cups leave a lot to be desired.

Great item. We've had it for about a month or so and it's still absorbing great. It can also be easily removed if necessary (e.g. to clean the inner windshield). We also like that we can take our pass after the ride so we don't stick it all the way in because getting out is a bit difficult once inside. Not impossible, but it takes patience. Otherwise we are satisfied and can only recommend it. PS If you like taking your pass off after a ride, make sure you put it on properly so it doesn't fall…

While this device works very well, there is one glaring design problem - the EZ Pass is very difficult to remove from its holder! The manufacturer has provided a very small hole on the bottom of the device to effectively "lift" the EZ Pass for removal. The EZ Pass opens slightly to be pulled out. What the device needs is a very simple modification, which is a finger-sized hole on its right closed side to allow the EZ Pass to be slid to the left so the pass can be easily grabbed by pulling it…

My other attempts to show off my EZ Pass have resulted in undersized suction cups in the bin so two of the same ones I bought tend to fall off. It's hard to judge the real holder based on what I've seen online. After the delivery I immediately regretted the purchase. Although the material was transparent and made of high quality material. Instead there are giant suction cups which of course hold the mount but what an eyesore. The holder is cheap, transparent (?), fairly opaque, and my A-Spec…