Technica Brand Fuser Kit LY6753001 Review

A cockroach decided to rest on my roller while it was printing. to squeeze. Bad prints and a burning smell every time I use the printer. Finally enough said and decided to install new rollers. The kit came with two reels, gloves and a small capacity USB stick with a PDF that links to a YouTube video with instructions on how to install the kit. Very impressive. The seller could just drop in a link and close the case, saving pennies. Instead they took the time to add a USB and gloves, small…

Good reason to buy and prepare. It cost me a third of what I would have to send to a repair shop or buy another printer. After trying to contact Brother over the phone for a repair they gave me a list of authorized dealers but most of them didn't repair. Those who repaired gave me an estimate equal to the cost of a new one. Being a bit tech savvy I decided to do the repair myself after doing some research and ordering this kit. Included was a flash drive with instructional videos on YouTube…

My picture shows a damaged fuser roller in my printer for which I bought a Technica brand fuser repair kit. The repair kit seems excellent, including a USB stick with a tutorial video (I haven't used it), a pair of vinyl gloves (to protect against fingerprints on the new wheels), and a top and bottom wheel. A few things I've learned. Study the subject online.1. Using non-genuine "compatible" toners in this particular printer may damage the fuser roller that I have pictured in this review. The…

These replacement fuser rollers did not work in my Brother MFC9340. After spending 4 hours disassembling and reassembling dozens of small parts and screws and updating the firmware, the printer kept telling me that it was overheating. It only printed one page before overheating and smelling awful. After researching this on the internet, I found that overheating was a common problem with fakes. I replaced it with an original Brother mounting kit. The Brother kit comes with almost everything…

Installation requires patience. It took 2 1/2 hours to swap out both rollers and removing the springs nearly killed my eye so wear goggles! Finally everything worked. At first there was a smell of burnt rubber, but after printing about 10 pages it went away and the machine cooled down. When you open the box there is a small plastic bag with rubber gloves, 2 breath mints and a USB stick. There are instructions on the flash drive. I didn't know this as I thought it was a gift with 2 mints. Not…