💪 TEMO SDS Plus Rotary Hammer Drill: Unleashing Powerful Drilling Performance Review

I use this as an adapter for a mortar stirrer. So far I have mixed over 60 sacks of multi-component mortar and 9 sacks of joint mortar with it. Blade slippage used in both drilling and drilling/impacting through extremely thick mortar was not observed. It's a bit unbalanced which would be a big problem if I was using it for something else. On the other hand, I don't care if I destroy it. It was cheaper than buying an SDS stirrer and if I run into problems I just weld the paddle to the adapter.

I bought this drill chuck adapter in January 2012 but haven't used it until yesterday (July 2012). It fell apart on first use. The gear clicked and the cartridge exploded. I also used a 5/32" drill bit. This is the first product I've bought from Revain which is completely useless junk. Too bad it's too late for a refund. The seller should refund all buyers .Based on the reviews except the first one, they are all junk.A cheap lesson learned.

Good features: I just held it and twisted the drill bit slightly and could tighten the chuck and remove. Use a glove if you have to do it this way. A few seconds. It took a long time for my drill to make a much smaller hole (it wasn't a rotary hammer). Check out my review of the Dewalt Cordless Hammer, I installed this cartridge on.One star deducted because it isn't keyless.UPDATE: The adapter HAPPENED dangerously the third time I used it.The shaft came loose from the head and then became…