🔧 TeraFlex 1943705 0.75-inch Lower Quick Disconnect Stud Kit Review

Not sure if a rivet would work well. This is a deceptive addition. it says "TeraFlex 1943705 3/4" Lower Quick Release Stud Kit", the "kit" contains enough parts to install a stabilizer bar with disconnects. Revain was supposed to download this rogue company.

They make a quality product. However, little quality control takes place as the smaller washer supplied did not fit the bolt supplied. Pretty sad. Also, the washing machine they sent was cheap and not like the real one that was supposed to come with it. hope you have better luck By the way, these are only spare parts for one side.

First of all there is a pin included in the kit. Then the pucks don't fit. One is too small to fit through the threaded end or pin. The second washer is larger than the pin, but the hole is too big for the nut on the threaded side. There are no instructions. Take a good look at your set. My jeep was raised with a passenger side bracket that does not remove easily so I was unable to remove this stabilizer bar.

This greatly reduced our route setup time. It used to take us an average of 10-12 minutes to unbolt the stabilizer links and remove them for the trail. When we first tried using it, the track ready time was reduced to 3 minutes, and it's decreased every time we use it since. We've got about 200 miles of trails on them including rock climbing and another 800 miles of highway use and they're holding up great!