🔁 Replacement Service for Compatible Thermostat Assembly Review

This fixes my problems turning my Atwood block off my 2007 Fleetwood toy tractor. I assume they were never replaced. Take your time and you will be fine. I connected the spark and sensor electrodes and thermal switch kit at the same time. Tip: First disconnect the 2 brown and red wires. Remove the exhaust pipe cover so you can peel off the old sponge sticker and just stick it back on when you're done installing the thermostats. Another tip: the instructions are not clear. Pre-assemble each…

This thermostat kit is designed for use with Atwood water heaters. There is a good guide in the bag. Overall, it's easy to install, but there are a few sticky areas (pun intended) that can be tricky. First, there are no pre-punched holes in the rubber mat for different models with different distances between the two sensors. That means you have to install both sensors and then try to slide the mat over the pins so they go through the mat. It's best to do this without removing the backing so you

This kit contains everything you need to replace your ECO and Thermistor. There were no instructions included with my kit, but I really don't need them to install these replacement parts. For those who don't know, ECO and each thermistor have their own size blade terminals. The wiring on your water heater will be similar, so once you're done it's virtually impossible to hook up the wrong wires. Just pay attention to the spade size and you'll be fine. One more note, if you're just replacing one…