💡 Efficient Thin Lite IB 716 732 Ballast - Superior Performance for Your Lighting Needs Review

That saved me from buying the whole lamp. But it's getting too hot! It goes up to 180F while my other lights are around 150F.

Since there is no spare light for this artboard, replacing the ballast is the best option. Easy to replace and cheaper if there is a replacement.

They were very easy to install. I found that they are perfectly fixed with the help of compression nuts (not included). They are excellent quality and I bought three of them.

Just check the model you have and they fit right in with easy swap out skills and work like a charm. You will need a set of rivets to properly install the module. The RV stores charged three times as much for the same product. This is an OEM replacement.

The colors of the cables did not match the ones I replaced ie all were Sam's colors except for the black and white power cable. Although the wires aren't marked at all and the schematics were very small, I calculated the location of the wires on the old one and tried to repeat it on the new one. I consider myself lucky that it worked

Never installed anything like this before, watched a few YouTube videos and gained the confidence to attempt this repair. Let me just say it was easier than I thought and the results were amazing, thanks for providing this item, it fitted my sleek 1989 Winnebago perfectly. It is actually brighter than the ballast in my other two thin lights.

I've been using the trailer for about eight years and have replaced these ballasts five or six times in that time. As an electrical engineer, I see that this project has not been updated since humans used computers to design circuit boards. The quality is poor, the price is relatively high for what they are. If I had another option, I would take it. LEDs are beginning to get bright enough to be a viable replacement that doesn't require a ballast at all. I buy them because they're easier to…

I have a RV with 6 headlights that uses this ballast. They had two F15 T8 bulbs and the light output was 25W. They were manufactured by Thin Lite Corporation. I replaced a ballast last week and it worked great. Then, to my surprise, the other light source failed. So I ordered another one and it was delivered last Saturday. The car is 10 years old. The old ballast was riveted. I snapped off the old rivets and attached the new ballast with velcro. I changed one cable at a time. You have a scheme,

It was hard to find, I spent a long time searching the internet for a replacement ballast for the 12 volt lamp I have in my house have wheels . . I was almost ready to replace the entire light, but I looked at all the replacement lights at my local RV stores where the lights are either smaller or different sizes. I haven't given up. I was always looking for new ballast. Browsing the Revain website I came across some small 12 volt light bulbs. But they didn't look like they would fit my…