🐯 Tigeracing Retractable Truck Bed Top Side D-Ring Tie Down Anchors Compatible with 98-2016 F-Series (150, 250, 350) & Super Duty – 3000 lbs Capacity (Set of 4) Review

Fits perfectly in the back pockets of my stock 2012 f150 6.5" cab. Easy to install and learn. Just make sure you get the right ones. I accidentally ordered the ones for the 5 inch bed and they didn't fit. It was my fault. The return was easy.

I don't know what old ones I had but they were tight when I got the truck and tight when I sold it. I tightened the screws, but after a few months of use, the anchors are loose (no screws) and are dangling in pockets. I can no longer tighten the screws.

A little pricey for the time I'm using it but nice product. Ease of installation. It sucks they only fit in the center and back pocket holes (8ft). Most of the front holes are offset too far from the plastic guide to fit properly. I feel like I would use the fronts more often than the mids or backs. Anyway, good product, just what I expected. It's great to have options when it comes to securing loads.

There's nothing weak about these anchors. Full metal and easy to install. Stainless steel anchor plate and nuts for hinge bolts. Aluminum base and lid. The aluminum lid has a nice black texture that I'm sure will get scratched. No plastic to break or warp. The latch is enough to hold them in the unfolded state and the springs hold them in place and wash them off with a light pressure. You shouldn't hang around. This is a quality design and build.

Just received these and installed 2 in 5 minutes, easy installation. They are perfect for my truck. Bed. This should be standard equipment on the truck. They are very durable. If you need instructions, you can follow them: 1. Remove the cover from the truck bed .2. Unscrew the screws at the bottom of the anchor .3. Insert the bottom block into hole .4. Lower one side of the stainless steel bracket, then raise to engage the 0.5 hole. Insert the other side into hole .6. Install the base and then…