🚗 Optimize Your Vehicle's Suspension with the Timbren FR250SDE Suspension Enhancement System Review

I had two sets of these springs. They worked great on my 2008 F250 but not so well on my 2001 F250. The springs almost touch the bump stops on the 2001 rear axle when it is on the ground and this causes a very unsteady ride. I'm not sure why, but it just doesn't drive that way.

Timbren Suspension Upgrade Kit was great! Perfect fit for my 2002 7.3 liter F250. A hassle-free system that adds extra stability to the 25-foot travel we're pulling. The truck weighed between 800 and 1,000 pounds and ran smoothly with a full load of firewood in the back. Installation went smoothly, but save yourself the headache and apply some WD-40 to the rusty fender bolts. It is best to spray the bolts and leave them overnight. After removing the screws, installation takes 20-30 minutes. No…

Timbren is a great company. I bought their kit for my 2001 6" F250 and wanted to balance it out with affordable rubber washers that you can buy. I contacted them about the strength of the 3/8x24 bolt that holds everything together and asked about a metal spacer bracket could be made to replace the ones for standard height trucks. everyone measured and said they would send me the spacers right away for free! man I couldn't be more impressed with the customer service I received and the…

They were relatively easy to install but help raise the truck to allow for maximum axle lowering. My 2002 F2002 4x4 didn't need an extra shim and left about 3/4" of space between the timbre and the axle stop and used the center hole to attach the timbre to the mounting bracket. Unless you hit a significant bump you can't say they are installed except when turning. The rear end when unloaded is taut but not uncomfortable. I just did my first ride with a 10k fifth wheel. The truck dropped 1" from

I was looking at different options between airbags and timbrens. After reading the reviews I decided on Timbren. Revain's delivery was quick. The installation took me about half an hour, most of the time just gathering the tools. I will say that I did the passenger side first which is on the opposite side of the gas tank for my truck. Soooo when it came to installing the shim I did it because it looked like I had a lot of room. Well, when I got into the driver's seat, the gas tank was full, and