🖤 Premium Black TotalMount Hole-Free Remote Holder for 5 or 6 Remotes - No Wall Drilling Needed! Review

My small desk is cluttered with remotes, pens, laptop, my cell phone and I don't know where to put my laptop when I need to look at it. I was wondering if there is a remote control holder on the market. I've been looking for Revain and I'm glad there are many available. I ordered this and am glad I did. Not only do I have a place for my remote controls, but I can also put my phone or tablet there if necessary. VERY SATISFIED WITH MY PURCHASE.

I never thought there was a better way to store remotes than piling them on a coffee table. Finish the meal. This installs with screws or the 3M command strip adhesive I use. It was easy to install, just follow the instructions and make sure the installation place is clean. The adhesive strips stick well and it doesn't seem to come off at all. I went with most of my remotes but added a version for a couple of very small remotes. The dividers were a welcome surprise and helped keep the consoles…

I bought the larger TotalMount to replace the smaller version. I installed the smaller TotalMount with 3M strips but couldn't remove it from the side table to install the large TotalMount remote holder. When I pulled on the bottom of the 3M bars, they just stretched until they broke, and I couldn't get the smaller TotalMount off. So now I have a smaller version of it that I can't use because the separators don't stay in it and now I can't even remove them. I do not recommend buying this…

There are two built in dividers about 20% from each end. There is a third partition that can be placed right in the middle. Each of the extreme sections contains a medium-sized console. If this third divider were left, the larger center hole could fit three very slim remotes, so it's possible that five remotes could fit - but again only if three were very slim and the center divider was left out. . With the center divider installed, each of the two side pockets can hold a decent remote control,

3 remote controls for TV and one for DVD player. My coffee cup on the table collapsed with a mess of remote controls. Only 2 remotes are used regularly, but all 4 should be on hand "just in case". When I couldn't stand it any longer, I looked for this holder and found it. I love this command tape - I have her other hooks. I have a storage cupboard here next to my chair where it can stick - I definitely didn't want to drill holes. The instructions were easy to follow - peel and click! and voila!

Probably a rating of 4.5. Easy to assemble, well made, serves its purpose. but. a little problem (for me). The photos should first show the shape of my remote controls. The only problem is the shape of the bottom of the bags. sometimes they mistakenly press a button on the remote (when placed in a holder or banged). This may result in an unintentional channel change, power failure, or the like. The reason is the tapered bottom of the bag (which serves to create clearance for removing the double

First of all I have to admit that I changed my mind about the attachment point so I tried to remove it. Also, I didn't wait an hour after installing it, so maybe that's why the tabs snapped in half when I tried to remove them - Total Mount's comment? I have found that the interchangeable tabs for this size 5-6 item are 3M Command Large Picture Hanging Strips. So if I can detach them from the wall without damaging them, I can use them to hang them again. where I should have placed it first…