Tow Ready Mounting 118144 Quantity Review

It's too early to tell if it will connect to the connector but looks like it should work fine. It must be attached to the underside of the bumper next to the tow hitch.

It works and solves the dangling attachment problem. But it doesn't fit well in the slot. Easy to loosen with a couple of vises to squeeze/bend it a bit in the grooves.

Sturdy and good looking. Compact size. I used my own self tapping screws and the holes were a decent size to put a solid screw in. The supplied bolts and screws were very small.

Fits and looks good, can be top or bottom mounted depending on hitch, looks solid, fasteners included work with pre-drilled or non-pre-drilled brackets, would buy again!

Installation takes 5 minutes. Ideal for Drawtite clutch. The 4-pin connector wobbles a bit in the holder, but the rubber dust cap prevents it from falling out of the holder.

Pretty expensive for what it is, a small piece of metal bent at a 90 degree angle. Otherwise it does what it should and makes a robust impression, but is still not heavily loaded. Makes it easier to hitch a trailer.

Finally a solution to the dangling wire harness that is ruining the look of the towbar. The pull coupler is already pre-drilled for this mount and the plug slips through. All wires are hidden giving the whole assembly a finished look. Glad I ordered this. Good upgrade.

Fits my draw-tire hitch perfectly. Holds Teknosha 4 pin spade connectors well. I've seen complaints of loose plugs, but I think this indicates a mismatch between products from different companies. The Draw-Tite clutch, this bracket and the Teknosha wiring harness are from the same company, which guarantees good compatibility. I installed my mount by mounting it up instead of down which allows the cables to be properly hidden behind the bumper.