🔧 Tram 3270 Stainless Steel So-239 to So-239 Antenna Mirror Mount - Enhanced SEO Review

The base is thinner than expected but sufficient for the Comet SBB5 39" Ham Radio Antenna (2m VHF/440MHz UHF) - this antenna weighs only about 9 oz. Can be attached any bird perch mount and I have successfully used it on my 2020 Freightliner Cascadia by using the exact bird perch mount screwed into the transom mount holes.Any HF antenna needs something a little stronger - although I believe it is for a typical CB antenna was developed.

I use this bracket on my truck's toolbox to support the Yaesu screwdriver antenna. I needed the SO239 side to be flat for this application and that's what I got. I bought another one to use as a mount for the same antenna in a field/base scenario. However, the width between the studs and the length of the studs is simply not enough to fit a standard 1.25" mast. Tram: If you made a bracket with holes just 1/8 inch wider (horizontally and vertically) and with half inch longer screws, you'd be…

Using Diamond Super Gainer SG 7900A on the transom mount of a 2015 Freightliner Cascadia with this mount. It's strong enough to handle that big, heavy antenna at 65 mph on the freeway. I am very happy with it. You can also use any antenna cable. I use LMR 240. Good that there is no antenna cable in the kit. In general I am satisfied. In addition, it is completely made of stainless steel, so after 4 months of operation of the truck and a lot of driving in the rain, no rust. I drive a truck in…

The base is thinner than expected but will fit the Comet SBB5 39" Ham Radio Cellular Antenna (2m VHF/440MHz UHF) - this antenna only weighs about 9 oz. Can be mounted on any bird perch mount and I've had it successfully used on my 2020 Freightliner Cascadia using the exact bird perch mount screwed into the transom mount holes.Any HF antenna needs something stronger - although I believe it was designed for a typical CB antenna.

Used to mount the antenna for my Yaesu FT818ND and Buddistick antenna for radio frames for portable operation on long hikes. Works perfectly! My antenna uses a 3/8" threaded mount, so I removed the SO-239 connector from that mount and replaced it with a 3/8" antenna mount I had on hand. Works great! Contacts made with 5 watts via USB as far away as Indiana off the coast of South Carolina. Does not negatively impact transmission loss - which is important for this QRP operator!

I use this mount on my truck's toolbox to support the Yaesu screwdriver antenna. I needed the SO239 side to be flat for this application and that's what I got. I bought another one to use as a mount for the same antenna in a field/base scenario. However, the width between the studs and the length of the studs is simply not enough to fit on a standard 1.25" mast. Tram: If you made a bracket with only 1/8 inch wider holes (both horizontally and vertically) and 1/2 inch longer screws, you would be