💡 Flexible 16AWG Wire Extension Cord for 12V/24V DC LED Strips, TYUMEN 100FT 2pin 2 Color Red Black Cable Hookup Electrical Wire, Ideal for Ribbon Lamp Tape Lighting Review

Great wire for LED panels or audio. I used it to power the new LED bumper lights for reversing. Both the negative and positive wire are connected together.

When you separate the cables, the rubber coating on one side or the other will separate, exposing the exposed cable. Rubber appears to have dried out or dry rot.

This wire does not disconnect well. When I separated two strands, the sheathing broke on one, exposing the copper. Noticing this, I tried to be very careful when breaking it apart, but it didn't matter. I would not recommend this product.

I use it for 12 volt led strips, it corrodes quickly and can't handle 12 volts for a kayak, it's even 16 gauge and still going bad , I'm thinking now, I you know, don't buy an unnecessary cable, bought in January more problems with the cable than with a toggle switch in salt water, and there in shrink wrap and still rusting

The two wires are not formed/pressed with sufficient independent definition. So when you make the first cut and pull them apart to attach them to the connectors it will strip the insulation from the red wire exposing the bare wire. Adjusting the manufacturing process to fix this might fix the problem, but it's a potential issue the buyer should be aware of.

Used for a light jeep project - worked great. The insulation is thick but flexible and easy to work with. FYI - the outside of the roll that contains the wire says 100 feet. The markings inside said 93 feet. I used all of it so I can't tell you what it really was. It should have been marked. I would buy it again for my next project, it shot well and was easy to use.

I liked the price and the flexibility. Unfortunately, CCA (Copper Clad Aluminum) has caused some problems. The 18ga coil opened up but the copper shell burned off when tinning the bare wires leaving only the aluminum to work with. Using solder became a problem so they brought back the CCA 16ga and 14ga and opted for the same coils but 99% copper. If you want to crimp or splice without solder, this wire is perfect.

I rarely leave a bad review but I don't care folks! Yeah, the coil of wire isn't that big of a deal. But sending a broken one is nonsense. I don't mean it broke in transit, I mean someone actively took the spool and put it in the box without a decent chunk of shoulder. I am very happy to occupy myself with this for the next 100 minutes. As for the quality of the wires, idk seems decent and the jacket is good.

Very bad insulation quality! Any attempt to "split" the ends, except with extreme precision with a razor blade, will result in the insulation being stripped from the wire, and the insulation will melt when attempting to cut weatherproof connectors. Because of this, at least 1/4 of a roll was wasted, and I don't trust it enough to use it in anything other than a "static" application. Spend a little more money to get something that's easier to work with and doesn't pose a potential fire hazard.

I don't write many reviews but I was frustrated enough with this product to feel it was necessary. The red and black wires are connected, making the project easier to work with. My problem is that you have to separate two wires to connect them or you need one strand. The rubber sleeve is very cheap and even if you start splitting with a knife and then pull to separate the two colors the sleeve will separate exposing the wire. I went through the same process with another brand purchased from the