⚙️ High-Quality Oxygen Sensor Set for Ford F150 F250 Ranger Expedition Explorer Escape and More – Replace# 15717, 15716, 15664, ZZC318861 Review

Depending on the mechanical ability of the person it will be difficult to install unless you are mechanically inclined.

Los coloque y auedo operativa de inmediato. Easy installation. Esperemos que tengan una duracion acceptable ya que es una mark generica

I had a broken sensor after about 4 weeks. Had bank 1 sensor 2 lean code replaced this product with another sensor and it went away

I did not receive the updraft and downdraft for my 2010 F-150. I only got 2 downlinks. Check your fittings before ordering as upstream and downstream electrical fittings are different.

Direct replacement for the oxygen sensor on my 2000 Ranger. When unpacked, both looked the same. I assumed it didn't matter who went where. They looked a little different from my factory but the rivets and everything were the same. I threw away a little Anicise and installed it, it works fine. Much cheaper than what they wanted in Autozone.

I recently sold the truck I mounted this on but until I sold it it held up. I had a cat code, I believe it was P0402 on my 1998 Ford F150. But after replacing the rear O2 sensor the code no longer showed. I don't know if it was an accident or what, but it worked. Not the easiest of installs just because I needed some tools to tighten, but if I had better tools (lift) it would probably be easier.

I haven't installed them yet but the DOWNSTREAM sensors pictured are for 2011 Ford Expedition with 5.4 Triton V-8 only . These are the sensors located in the catalytic converters. The top sensors have a different connector (square shape). They appear to be of good quality and well packaged. I'll update the quality info after I install it and ride it a bit.