🔌 3 Pack VCE Single Brush Wall Plate with Single Gang Low Voltage Mounting Bracket, Cable Pass Through Insert for Wires, Single Gang Cable Access Strap, Wall Socket for HDTV and Home Theater Systems Review

I have a desk at home and a TV above the wall monitor. I hated looking at the cables so I decided to get them and it was great. I have too many cables to have a dedicated panel like 3 HDMI and power. So it's great to just run the cables through the wall and get them out from under the table. I recommend!

This is a good wall solution for those who, like me, want to avoid a backsplash; Each connection may degrade the signal quality. But be careful when cutting, because the perimeter rectangle that attaches to the hole in the wall is only about 1/8 inch thick; This is enough to keep it in place.

Fairly easy to install, no template included so I traced the inside dimensions but I had to cut some more at the drywall. The barb on the back that stops the flaps from attaching to the drywall was too long for my wall and hit the back of the outside wall so I had to trim it off by half an inch. All in all a great product for the price!

I usually buy these at hardware stores but they are sold out. You can't complain about them at all. They appear to be well made, fit very well and look great. Will definitely buy again if I need another one. Top Tip: Just buy 3 packs even if you only need two. The difference in price can be a dollar, and if you're like me you'll find a use for the extra charge.

Had to install local terrestrial antennas as Direct TV lost most of my local channels. DTV sent me antennas free of charge that would work with my DTV system, but it had to be plugged into the main unit and the antennas had to be in the opposite room to get good reception. This product has allowed me to run the cable through the wall and it looks very professional. There are no instructions, so plan ahead before attaching anything.

The camera mount was mounted on a stud and there was not enough room to route the cable into the predefined slot that is part of the mount. So I had to leave the wall on the opposite side of the counter. It held the camera they wanted but the wires on the other side. It was the perfect solution to this problem. I also used this when I routed the wire behind the TV where the wires went into the wall.

As long as you have it handy these wall panels are easy to install. I used the bracket as a template to mark the outline of the hole and cut out the hole. The mount is solid and the brush and faceplate are securely attached. The bristles in the brush hole are stiff enough to effectively cover the cords so you don't see a big black grip stuck in the wall. I like that the brush area is separate from the bezel so I can use my own bezel if I want. It seems odd to me that there are 3 in the box as I