🖌️ Wall Lenk L10SC Stencil Cutting Pen: Precise 18-Watt Tool for Effortless Stencil Design Review

Very good stencil cutter, but you have to keep moving on the stencil sheet or the stencil will melt

I managed to bend the tip but the tip still works. The handle gets hot. Carefully. Practice a lot or you'll get a point and don't leave for too long or you'll have big holes.

It works to a degree, but I end up using the chord for complex work. The tip seems to be clogging the frisket and not working properly.

It was a good product, the tip is sharp, it wasn't small enough to make 1 inch cutters as I wish, the razor cut would be more precise but it works very well with duralar and acetate plates! Heats up quickly and comes with a stand, a good tool for cutting friskets!

I plugged it in just long enough to make sure the tip was warm enough to do a few test cuts on the screen film - it works but I'm a little disappointed with the tip. I was expecting something more like a heated micro knife; it's more like a micro soldering tip, ie I doubt it would be possible to achieve precise/complex/small jumpers with this tool. Inexpensive, it's ideal for learning to cut stencils and creating stencils with large designs. And due to my limited use, it seems much easier to…