💪 WEN 73016 Heavy-Duty Chrome Shop Bar Stool with 300-Pound Weight Capacity Review

I bought 4 stools, each one had something wrong, either the bolt broke or the nut under the seat. no, I mean none of the rods fit, every stool had to be pushed somehow. I had to stop after the first one and just send them back. The latter is completely broken because the leg is not attached to the round bar. 1 star from me is a lot more than minus 10, the only nice thing about it is the seat itself. As a welder, I could come up with a better design than the one they sent me! In fact, I will…

Made for a workshop, not a bar. Why not for the height of the countertop and not for the bar? You have to shorten your legs. The "wrong" pillow is the worst. They make you make it look like 5 inches thick when it's actually 1/2 inch thick pillow. Don't listen to anyone claiming to be an expert, but this chair is SO hard to put together. A professional must install all the screws by hand before tightening them. So it was easy to assemble. I really don't know why people are complaining about its…

I bought 3 of these and am very mechanical by nature. So take my comment seriously. First of all, I would recommend Revain to remove them from their website. It's a real pain in the butt to assemble. Here are the problems I encountered; The screw holes aren't fully punched, the frames aren't aligned, the screws and bolts are cheaply made and come loose, and the threads in the seat are pushed into the seat so there's no way the seat can be attached so you'll be returning it have to. If you can…

I don't usually write reviews but thought I'd help out prospective buyers. A very good stool for the price! The seat is very comfortable and durable. The instructions are pretty poor and don't help at all, but putting it back together isn't rocket science. Pretty easy to assemble. The only reason I didn't give 5 stars is because the hardware that comes with it sucks! Made of cheap material, removed with a few turns! The legs need to be tightened with screws, but most likely all the screws that…

Nice sturdy stool assembled. The main downside is that it is quite difficult to assemble as the parts are not round and not square so the stool which should have taken 20-25 minutes to assemble required 2 hours of bending and forcing to adjust as well as a trip to charge. Hardware store for additional fasteners. If you do not have at least medium manual skills, you should avoid this stool. Sure, YMMV if you're lucky and get one that has almost exact parts matching. Also, the metalwork was rough

1. Assembly was a nightmare. The instructions showed that the inner rings had three set screws. In fact, there are four locating bolts for the inner rings, and the inner rings have four locating bolt holes. I had no problem installing the first three screws, but the holes for the remaining fourth screw did not line up properly. I was able to bend the chair's legs to line up the bolt holes, but the last bolt didn't go all the way through the holes. After bending the stool legs further, I was…

First review. The set is the same as the work chair. Immediately after unpacking, I noticed a not very smooth finish on the chrome part of the stool. While I didn't expect perfection, I did expect quality. The welds of the round tube were not smooth, we could have made this point less noticeable. The rest looked like scratches. While this is a small improvement, it's clear that quality/performance is not the top priority. The instructions are, well, not really any, just a parts manual (maybe 4…

PLEASE READ THIS REVIEW BEFORE PURCHASING THIS PRODUCT! I ordered it because it had a 4 star rating and was very cheap. I should have listened to feedback on build issues. Putting this stool together was a nightmare. At first you think the bolts are too short or the base plate (large round bar) is too small. It took me over an hour to put it together and I didn't actually finish it. I'm missing a screw on the footrest. My wife had to struggle to spread (spread) her legs with her strong leg and…