🔧 Wiha 26390 Hex Metric Precision Screwdriver Set, Range: .7 - 3.0mm, 7 Piece Kit Review

I saw them in a YouTube video where a person used them and that's exactly what the doctor ordered when they were used to tighten and loosen hex bolts. Their quality is top notch, sizes vary as listed, and they come in a resealable plastic container that you can use to keep them separate. Just don't try to tear open the packaging to get it out when you first receive it. . . (Two-sided clear plastic comes with staples, just use what you use to remove the staples and the packaging can be reused.)…

I bought this driver set to work on my RC Crawler. I would not recommend them for this application. Screwing and unscrewing screws on an RC car takes time. With these drivers, the only place you can grab the crank is halfway up the shaft. The end of the screwdriver is not large enough to easily pry open the screws. You will find yourself pinching the driver with your thumb and forefinger and using your fingers to rotate the driver instead of squeezing it in your hand and using your wrist. On…

I chose these because of the Wiha name - have heard good things about this brand. I had a set of Bondhus drivers that lasted almost 5 years but my 1.5mm driver has worn out (which has a ball end). I chose this set. They seem to be of a higher quality compared to the Bondhus in terms of driver metal and connection to the main body. I don't think the Wihas wear out that quickly as they are solid throughout. I also like that it has a swivel end, very handy that it can be twisted to tighten. I…

These are the screwdrivers I use the most, often in lieu of the high end T-handle or ball end screwdrivers. They are light and compact. I keep mine in a plastic wrap and it lasts quite a long time. The hardened tip of the screwdriver seems to fit very snugly in the sockets on the fasteners, which is probably why mine wears out very little (unlike some loose fitting screwdrivers). The plastic handle tapers to a narrow end that can be twisted between index finger and thumb to quickly install long

Not a bad set. Durable and well made. Definitely better made and more durable (in my opinion and experience) than anything I could order from China for example (note: some things made in China MAY be of exceptional quality. Tools don't usually come with them). However, I was a little disappointed when the 1.5mm started to round off a bit after moderate use. I needed to fix an old 1990's RF spectrum analyzer. The analyzer's hard plastic front panel control knobs slide on steel control rods…