Winters PETM213LF Pressure Gauge: High Accuracy and ±3 Range Review

This is a very high quality meter. I can't tell if it's made in China or not as it doesn't say it on the device or the box. But it looks like it's well done. You can get a similar sensor for a few bucks less, but I doubt you'll be just as happy. With the red arrow you can save the maximum or minimum value. The black needle is precise and has a very smooth and smooth movement. You can watch it rock back and forth and then stabilize again as you or your neighbor use the water.

Meter was packaged in a box labeled PETM213LF but was actually a liquid filled Winters PFQ803LF PFQ-LF. I couldn't even find a label on it, so I looked for a picture on the Revain and Winters website. I asked for a refund in $ and Revain credited my card quickly (5 stars for that). Very good!. Turned around and bought a Watts 276H300 from Revain for about $23. I am a homeowner who wants to test both static and impulse pressures in my various hose/heater bibs. I have some on the city regulator…

I used this maximum pointer pressure gauge to diagnose high pressure surges in the lines of my house at night. It attaches to a tube bib or laundry tub. Mine had to be tightened with pliers as the internal threads were very deep, larger than a standard hose fitting. It would be better with 2 seals or a slightly smaller threaded ring. I've tried taking my sink, two hose bibs outside and also sewer locks at my neighbor's with similar results. Tighten just enough to seal it! Which is probably more