WMPHE Integrated 2001 2007 69301 0C010 64680 0C010 Review

Durability to be determined. The installation was successful with the help of a YouTube video from Dan the Man Garage. I could tell the broken latch wasn't factory so we'll see how long that lasts.

Very poor fit. And it's so stiff I had to make a gap for the factory release mechanism to work properly. Very disappointed. But you get what you paid for. I buy a bullet and now I buy OEM.

I just installed it myself on my 2007 Sequoia Limited. I watched a short video on Youtube and then found the part on Amazon and ordered it. Installation took about 30 minutes and my broken tailgate would not close without straps. At almost $200,000 for this car, I'm glad I didn't spend $1000 on a mechanic's replacement.

I had to use a cable lug because the cable was too long. After installation, the sunroof sensor started turning on constantly, even when it was closed. This will set off my alarm/beep and drain my battery. I took it to the dealer and had to spend $375 to replace the $200 clasp. Probably a broken wire. waste of time. Wouldn't do it again.

Wrong cable length. It doesn't fit a Toyota Sequoia without spending a few hours modifying what should fit. Very dissatisfied with my purchase, please for God's sake don't buy this! To update! I replaced the deadbolt anyway and it broke already after opening the door maybe 20-30 times. DO NOT BUY!

Update: Cable lasted less than 2 weeks. My 2007 Sequoia trunk won't open anymore because the cable is too long. Two of the holes were unthreaded so the screws from the stock part couldn't get in. Now we need to figure out how to get this part to work, having already removed the tailgate. separately.

I had high hopes for this latch. I installed it and it sticks but doesn't keep the door closed. I'm sending it back. I went to a Toyota dealership and paid through the nose but it works fine out of the gate. The tolerances were wrong enough for it not to hook and hold. This wasn't my setup as the OEM went the same way and went straight to zero adjustment. Save yourself the headache and simply buy quality replacement parts. It's a waste of time removing the panel twice to get it right once.

So the part itself is fine. There is no cord length and you will mess up your alarm or fail to open it with the handle. It all depends on the length of the cable. You can use your old cable if it's in good condition. It wasn't mine. Here's how to fix it: after installing your device, leave the cable loose and slack. Take 2 zip ties and tie them as tight as you can under the ball at the end of the rope. Cut off the excess end of the plastic zipper. Insert the entire zipper ball you created into…