🚴 WOTOW Bike Kickstand | Skewer Mounted Adjustable Quick Release Stand for Lightweight Alloy Metal Rear Side Support | Spring-Loaded Kick Stand for 24-27.5 Inch Mountain Road Bike BMX MTB Review

I love this stand! Bright design, easy installation and configuration. It has a square spacer that cleverly slides into the chainstay to prevent re-snapping. Feels well made and is very light. My bike has a medium sized aluminum frame with 26" wheels, your mileage may vary.

Bought for my custom Sirrus x 5.0. The hole that the axle goes through is only about 1/4 inch and doesn't appear to be enlarged. There is a piece of metal that provides stability and prevents drilling. The Sirrus axis is too big to fit through this hole in the stand. The stand seems good quality and very light weight so I'm disappointed that I had to return it.

I recently ordered a new mountain bike. It arrived very well packaged and I put a few things in it that needed installing. It didn't come with a stand, which I found odd. So I did what I always do: open Amazon and start researching. I chose wotow because it fits every bike. arrived on time and I installed it in less than 10 minutes. and it works great. The bike was never dropped during use. I am delighted with the product and the price.

Bought for my carbon frame bike. Most footpegs are bolted to the frame, which is not possible on CF bikes as it will damage the frame. This product is easy to install with the rear skewer. Fits perfectly, has multiple adjustments and is very durable. It is possible to lengthen the footrest and I chose the maximum length which turned out to be perfect. Very light weight. Great product and bought two more for my other bikes.

Easy to install and durable, see picture. 18/2021 A few days ago it completely collapsed. The key part attached to the eccentric on the running board turned out to be very thin (see photo) and does not have sufficient strength. 27.04.2021 received a replacement. Very pleased that the response from the cashier was very quick. However, the durability of the product is still an issue.

later This is a very light stand and will not fit heavier bikes. Very easy to install. This is a very good stand if you're looking for a basic stand for a bike with smaller wheels, like a 406 recumbent or folding bike. You'll need to remove the screw holding the strap to the leg and pry it off, then trim it appropriately , drill a hole, then replace the screw. You may also need to cut/file the area around the skewer arm to give room to block. It's pretty easy. I replaced the overly complicated…

--------- Update: 02/08/2021 --------- So my wife is already using this for a while and it works Well. most of the time. The only major issue here is that with the footpeg set that far back, the bike has a tendency to tip over if the front wheel is rotated too far the wrong way (away from the footpeg) - sometimes you just leave the wheel in front. can be problematic depending on the wind (especially on the beach where one of our trails runs). We solved this problem by turning the steering wheel