Review on 🚴 WOTOW Bike Kickstand | Skewer Mounted Adjustable Quick Release Stand for Lightweight Alloy Metal Rear Side Support | Spring-Loaded Kick Stand for 24-27.5 Inch Mountain Road Bike BMX MTB by Luke Liu

later This is a very light stand and will not fit heavier bikes. Very easy to install. This is a very good stand if you're looking for a basic stand for a bike with smaller wheels, like a 406 recumbent or folding bike. You'll need to remove the screw holding the strap to the leg and pry it off, then trim it appropriately , drill a hole, then replace the screw. You may also need to cut/file the area around the skewer arm to give room to block. It's pretty easy. I replaced the overly complicated centering sleeve with a simple M5 lock nut with a few layers of shrink wrap. Finally, I was concerned that the smooth finish on the inside of the interface might slip, so I took the paint off, rubbed it down, applied some laminating epoxy, then sanded it down with 120 grit sandpaper, let it dry, and I had a very abrasive surface that didn't move when pressed.