🚗 XiKe 1 Set Trailer Wheel Hub Kit, Fits 1-1/16'' Axles, Including L44649/10 Bearings, 12192TB, 15192TB /34823 Seals, 10-60 Seal, OD 1.98'' Dust Cover, and Cotter Pin. Review

Has all the parts I need except washers behind the nut. Not sure what the purpose of the tab on the washers sent as a kit is. Put in new bearings before evening.

My cargo trailer broke last summer so I replaced both wheels. Since I still had a good wheel, I decided to replace the bearing so I had a spare. Haven't ridden this bike yet but the bearings installed with no problems.

Supplied with cotter pins and outer covers. Appears to be good quality. The bearing noise is gone now. Haven't changed an axle bearing in years, would appreciate instructions, particularly on amount of grease and correct torque. I know your axle nut might be too tight.

Can't judge how they are worn yet, but they fit well. The original bearings weren't bad, I've only heard that they've been replaced over time, which I've done. The racing fit was basically the same as the original. Dust caps, they are tight, very tight, had to bend a bit to fit, I kept my old ones just in case.

Had to replace worn out noisy bearings on my small cargo trailer. It was noted that they did not use the usual 1" trailer axle, but a slightly smaller size (25mm). This kit had everything I needed, 4 cone bearings, 2 oil seals, 2 caps and even cotter pins. Better quality than what I removed and everything fits fine. No more noisy camps!

I have a trailer imported from China with "not so standardized" hubs and axles. They were close but still unfaithful. A bearing ring rotated in the hub and all bearings rotated on axles. Nothing I can't pull off with a couple of mid shots. Not ideal but suitable for my trailer use. Note that these bearings are NOT to blame. They are EXCELLENT and good quality. These imported axes are NOT!

The kit includes large and small oil seals and even an oiler. It has been difficult to find these in the past. It is recommended to check the hub after the Removing old races and warming before installing new races (Store races in a cool place) It is recommended to use cotter pins slightly larger than those included in the kit.

This kit contains everything you need except grease to replace bearings, grease fittings and dust caps on 4x8 port cargo trailers. My trailer in particular is a 1200lb capacity model, not a super heavy model, although I expect it will work on both and possibly others with 25mm axles and the same wheels. This is a quality bearing kit, the trailer rolls well and smoothly again. If you've never changed bearings feel free to lubricate them, they won't last long without a generous amount. You have…

This is quite a long review. Bought a set of XiKe bearings for my Northern Tool Ironton 4x8ft trailer (CHINA trailer in box). Same as port cargo trailer. If you have one of these trailers or your stock is 30205 then you should buy this kit. This is a 25mm spindle bearing kit. Don't buy a traditional 1" spindle bearing kit. The 1 inch kit is slightly larger than that used in the marine trailer. My only complaint is that the production photos show this kit with new metal dust caps that have a…